Acoem AT-400 Nominated for Plant Engineering's 2024 Product of the Year! Vote Now to Help Us Win

The OJT portion of a recent XA alignment training class led us to a two-cell cooling tower that had a run of bad luck–motor bearing failures, internal supports broken, visibly shook when it ran, etc.

A cursory visual inspection revealed no shims under the 25 HP motor and a horizontal gap difference of ~3/8″ between the gearbox hub to the spacer shaft. That 3/8″ gap over the 8″ coupling works out to 47 mils/in of angular misalignment! No wonder it was falling apart!

Cooling TowerThe motor/spacer/gearbox were ‘roughed in’ pretty quick using the handy line lasers and 30 mm detectors on the XA sensors. The XA was setup to take readings in Tripoint mode and a first set of results were obtained. The vertical results showed the motor to be too high by ~75 mils. Remember–there were no shims under the motor. So now we’re base-bound. No problem. The FeetLock™ function was activated and the optimal move was calculated. A tiny 10 mils under the front feet of the gearbox and 45 mils under the front feet of the motor was all it took. Since the motor was also bolt-bound, FeetLock™ was used again to find the optimal move. After re-measuring, a slight additional horizontal correction was made and then re-measured one last time to verify the results.

An hour and 45 minutes is all it took to rough it in and align it  within spec for it’s operating speed. After start-up the shake was gone and the customer was smiling.

Share Blog Post

1 Comment

  1. Getting Started with Cooling Tower Alignments on October 17, 2011 at 7:45 pm

    […] every week during one of our alignment training classes, we’ll get a question about aligning cooling towers. Most facilities we visit have them and a lot of folks aren’t too sure how to approach the […]



Subscribe to the
Acoem USA Blog

  • This field is for validation purposes and should be left unchanged.