Categories: Shaft Alignment

Thermal Growth Compensation – Growth Versus Targets

By on October 25, 2011

The object of precision shaft alignment is to position machines so that the rotational centers meet a specified tolerance at operating conditions. Machines can and will move due to temperature changes or process forces so this means that some machines need to be “misaligned” in their off line or cold condition so that they will be precisely aligned when they are operating. Compensation for growth can be accomplished with many laser systems but people sometimes get confused over how to compensate for it. Of course, this only works if the targets are correct but that is a discussion for another time.

Growth versus Targets

Thermal growth is the actual relative change in positions of the moveable and stationary elements. Target values are the compensation for that growth. Target values can be entered into all Fixturlaser GO and XA alignment systems. Assuming the targets are correct, the user can align to his angle and offset tolerances and the machine will end up “misaligned” cold but will grow into alignment when running.

Example

If the motor were to grow 20 mils (20 thousandths) and the pump does not grow then the target values would be -20 mils at both motor feet (or -20 mils at the coupling with a 0 mils/inch angle).

Thermal Offset Graph

Inputting Offset Information Into the Fixturlaser GO Pro

1 – Select targets (thermometer)

2 – Select either feet values or angles/offsets3 – Feet values screen4 – Targets of -20 mils at the feet of the motor5 – Aligning to targets (see thermometer in upper right-hand corner)6 – Aligned  with -20 mil compensation

Are you inputting target values for your alignments? How do you decide which ones are offset and which ones aren’t?

About the Author

One response to “Thermal Growth Compensation – Growth Versus Targets”

  1. […] thermal growth must be factored as part of the alignment process. […]

Leave a Reply

Your email address will not be published. Required fields are marked *