Posts tagged with: “coupling tolerance”

Stupid Questions

| | | | |

By on February 8, 2018

While on the road conducting precision shaft alignment training I run across a wide range of skill level. It is not uncommon to have a lot of questions. I like it when there are questions, that is usually an indication that the trainees are engaged. It is also not uncommon that a question starts with, […]

Read More

Coupling Tolerances vs. Shaft Alignment Tolerances, What’s The Difference?

| | | |

By on June 24, 2016

Plenty! This question still comes up fairly often in our training classes. If you look any of the coupling manufactures installation instructions there is a chart for the maximum allowable misalignment based on the coupling size. These tolerances are for the coupling, what about the machines the coupling connects? Shaft alignment tolerances are more about […]

Read More

Foot Tolerances vs. Coupling Center Tolerances

| |

By on May 4, 2012

Pardon the hiatus last week, folks. We did a little maintenance on the blog–be sure to check out the new tabs up top designed to help you navigate better. Let’s jump back into it–foot tolerances vs coupling center tolerances. It’s a hotly debated topic in some circles. I’m no great debater but let’s take a […]

Read More