Posts tagged with: Machinery Bases

Qualifying the Fixturlaser Level When Using a Fixture

| | |

By on September 16, 2020

The Fixturlaser level is calibrated to earth level out of the box. If the level is used without a fixture it reads level directly. If a fixture is used, however, you must first qualify the level with the fixture. This is a very simple procedure when using the Fixturlaser NXA. Level measured with no fixture […]

Read More

The Fixturlaser Level – a digital two axis high precision machinists’ level

| | |

By on August 31, 2020

The Fixturlaser Level is a high precision two axis digital machinist level. The primary application is base leveling. The Fixturlaser Level offers the following advantages: Two axis live measurement Calibrated to earth level out of the box No line of sight required Immediate feedback with live values Documentation of results Simple to qualify to other […]

Read More

The Fixturlaser Level

| | | |

By on May 20, 2020

The Fixturlaser Level is a two-axis level sensor that can be used wherever precision level measurements are required. It can be used to level machine bases or beds, bearings and journals, or for measuring “twist” on linear guide ways. The accuracy is very precise with resolution down to 0.01 mm/m (.1mil/1”) with a range of […]

Read More

Soft Foot! Or Are You Just Pulling My Leg?

| | | | | |

By on February 12, 2018

It’s no joke that many machines operate with high levels of vibration due to soft foot.  These same machines often have a decreased life span due to this condition. Soft foot is a condition that should be eliminated during the precision shaft alignment process, if you’re performing proper alignments at all.  This condition can manifest […]

Read More

IT’S ALL ABOUT THE BASE, PART 2

| | |

By on November 4, 2015

One of the biggest problems facing maintenance personnel in the shaft alignment business is the quality of the equipment base. Poor mounting base or platform construction will almost always result in machine movement. If the moveable machine (or the stationary) is not mounted to a solid platform capable of withstanding the weight of the equipment […]

Read More

It’s All About The Base, Part 1

| | |

By on October 28, 2015

From the editor – The VibrAlign Trainers see many different machinery base designs and installations during the OJT portion of our training classes across America. Some bases are quite substantial while others are flimsy and actually downright horrible  Poor bases have a negative impact on rotating machinery reliability and can certainly be a cause of […]

Read More