Using Your Laser Alignment System to Check the Validity Rule

The validity rule is an important concept in precision shaft alignment. It can be used to confirm that your readings are accurate and is why we don’t have to rotate a full 360 degrees in order to get accurate alignment information. Here is a previous blog post with an embedded video that discusses dial indicator…

Read More

Flatness Measurement Repeatability, Part 2

In a previous blog written by Brad Case (Sept 24, 2019), he explained how to perform a repeatability test and why it is good idea to do so. Here are few other items that have contributed to repeatability issues. 1)      The top rails were not sufficiently clean prior to taking readings. Paint was not removed,…

Read More

Flatness Measurement Repeatability Test

When performing the Ariel ER-82 Top Plane Compressor Frame Measurement, surrounding reciprocating compressors in operation may cause repeatability issues due to excessive vibration. To compensate for high/excessive vibration the Sampling Time (measurement time at each measurement location) in the Fixturlaser NXA Ultimate can be lengthened as needed. The NXA has a built in Repeatability Test…

Read More

It’s the Little Things Revisited

During a recent training class at the facility of a client who had their initial Shaft Alignment Best Practices training class 5 years prior, I found out none of the previous class attendees were still in maintenance. The “new” guys never had anyone show them the proper use of their laser and most had no…

Read More

Dial Indicator Alignment – Bar Sag Still Exists in 2018!

And it just may be a lot more than you would think. While visiting a customer site to do an alignment check using the EVO laser alignment tool on a 1750 HP Electric Motor / Boiler Feed Water Pump / 3574 rpm, measurements were taken several times (x3) to make sure the values were repeatable. …

Read More

Fresh Perspective

We all have run into situations where things just aren’t working out the way we think they should. Kind of like not seeing the forest for the tree’s. Part of our profession as trainers at VibrAlign is fielding support calls when a client has questions or has reached the point of frustration where they just…

Read More

Other Influences to Precision Shaft Alignment Results

Over the years we have fielded several technical support calls from maintenance personnel having repeatability and soft foot issues (during an alignment) all of which had a common issue; other influences. Meaning not the typical looseness, coupling backlash, soft foot issues. During the “heat of the battle” to get the precision shaft alignment job finished…

Read More

Don’t Bet Against Your Laser Shaft Alignment Tool!

During the classroom portion of a Fixturlaser GO Pro training class, at a sheet metal processing plant, one mechanic insisted the GO Pro alignment results were not repeatable in the field. The mechanic had the opportunity to use their GO Pro once before the training class and was convinced it would not repeat For the…

Read More