Vibralign Blog

Balancing| Fixturlaser Smart Machine Checker| OneProd Falcon| rotor unbalance| unbalance

By Stan Riddle on October 9, 2019

In our last “How To” we talked about the trial run – using a trial weight and location, to calculate the amount and location of a correction weight, which should correct the unbalance.  Most modern-day balancing tools do the math for you.  Even though these tools calculate the correction weight and location, it is good […]

Balancing| rotor unbalance| unbalance

By Stan Riddle on April 25, 2019

Once unbalance is determined, the original unbalance run (amplitude and phase) is measured, and a trial weight size is determined, the next step is where to place the trial weight. If you have no balancing record for this rotor, where to place the weight is little more than a guess.  But there are some things […]

Balancing| Imbalance| One Prod Falcon| rotor unbalance| SMC| unbalance

By Stan Riddle on February 22, 2019

In our last Balancing How To, we discussed how to set up and get your original measurements on the rotor to be balanced.  This How To discusses selecting a proper trial weight. A trial weight is used to make a change in the original vibration amount and direction.  Changing either the AMOUNT of vibration (amplitude), […]

Imbalance| rotor unbalance| unbalance

By Michael Keohane on February 7, 2019

Unbalance (Imbalance) is often defined as the unequal distribution of the weight of a rotor about its rotating centerline. A rotor can be balanced either in-place or in a balancing machine assuming unbalance is the issue and weight can be added or removed.  Modern balancing instruments will do the math for you. I originally learned […]

Balancing| OneProd Falcon| rotor unbalance| SMC| unbalance

By Stan Riddle on January 30, 2019

The recent blog on troubleshooting balancing ( https://vibralign.com/other-topics/smc-touch-tip-using-the-smc-when-unbalance-is-diagnosed/ ) brought up some additional questions from our readers, so let’s tackle them in order. The first one is setting up to perform a balance job. NECESSARY EQUIPMENT FOR BALANCING If you have gone through the checklist and confirmed unbalance, you will need: A machine to perform […]

Balancing| rotor unbalance| Smart Machine Checker| unbalance

By Stan Riddle on January 7, 2019

The Fixturlaser Smart Machine Checker (SMC) is a great balancing tool (for me personally, it’s the best balancer I’ve ever used).  Unbalance is one of the most common machinery problems on rotating equipment, especially fans. If you get a diagnosis of unbalance, be aware of these tips: Be mindful that a rotating mass, once balanced, […]

eletric motor bearing failure| lubrication| lubrication tool| rotor unbalance| Smart Machine Checker| unbalance

By Stan Riddle on September 13, 2018

We recently published a blog about using the Fixturlaser SMC as a lubrication tool. https://vibralign.com/other-topics/using-the-smart-machine-checker-as-a-lubrication-tool/ Ironically, just a couple of weeks later I received some photos from a new SMC customer.  He got a report from his SMC stating that a chilled water pump was experiencing motor unbalance.  He took the motor apart to inspect […]

Balancing| condition monitoring| machinery diagnostics| ONEPROD Hawk| rotor unbalance| unbalance

By Stan Riddle on June 20, 2017

Electric motors are almost always well-balanced when they leave the motor manufacturer.  But occasionally, motor unbalance problems are picked up with vibration monitoring tools, such as the OneProd Hawk. Here are some easy troubleshooting methods to determine the cause of unbalance in the motor. An electric motor’s rotor, like any rotating mass, cannot become out […]